Use alternative terminals without breaking the line
Alternative railway terminals must be reachable from the last signal before the station. The line manager marks that decision signal and warns when an enabled terminal cannot be reached.
Quick facts
- Documented answer
- Alternative railway terminals must be reachable from the last signal before the station. The line manager marks that decision signal and warns when an enabled terminal cannot be reached. ↗
Procedure
Open the line manager and select the affected line. Select the stop, open alternative terminals, and enable only platforms reachable from the marked decision signal. Inspect both the incoming and outgoing paths before allowing traffic to continue.
Diagnose the result
If a platform is idle, check reachability before adding trains. If every platform is reachable but occupied, inspect dwell time and departures. A platform beyond an incompatible switch cannot provide extra capacity merely because it is empty.
Common mistake
Adding platform capacity without checking the signal that decides which platform can be used.
Evidence and version scope
The cited official manual supports the documented interface and mechanics. The procedure above is editorial guidance for inspecting your own save; it is not a claim of a tested speedrun or a guaranteed outcome. Record your installed version, gameplay settings and mods when comparing results. Release-build version: Unknown.
Connected operations
Parent: Network operations ↗
Next action: Network operations ↗
Planning tool: Network Checklist ↗
Version and changes: Update desk ↗
Sources and verification
Facts are attributed to official post-launch documentation. Procedures are editorial inspection advice; they do not claim a tested save or release-build benchmark.
Last checked: 2026-10-02 · Evidence before estimates · Corrections