Diagnose a single-track passing siding
The TF3 manual's passing-siding example resolves two opposing trains by placing signals at the ends of the siding. Reservation paths must let one train wait while the other clears its route.
Quick facts
- Documented answer
- The TF3 manual's passing-siding example resolves two opposing trains by placing signals at the ends of the siding. Reservation paths must let one train wait while the other clears its route. ↗
Procedure
Pause and follow the two opposing lines through the siding. Identify where each train can wait clear of the shared section. Put the waiting points beyond the switch with clearance for the complete train, then inspect the line preview and resume a small test.
Diagnose the result
If both trains reserve through to the opposite terminal, shorten the competing reservation paths at the siding. If a stopped train still covers the switch, move its waiting point. If routes disappear, check one-way signals rather than increasing train count.
Common mistake
Placing a signal so close to a switch that the waiting train blocks the other route.
Evidence and version scope
The cited official manual supports the documented interface and mechanics. The procedure above is editorial guidance for inspecting your own save; it is not a claim of a tested speedrun or a guaranteed outcome. Record your installed version, gameplay settings and mods when comparing results. Release-build version: Unknown.
Connected operations
Parent: Network operations ↗
Next action: Network operations ↗
Planning tool: Network Checklist ↗
Version and changes: Update desk ↗
Sources and verification
Facts are attributed to official post-launch documentation. Procedures are editorial inspection advice; they do not claim a tested save or release-build benchmark.
Last checked: 2026-10-02 · Evidence before estimates · Corrections